SUNBLIND PROFILES Hakkında Teknik Bilgiler
Aluminium SunBlind profiles are designed to reduce the solar heat reflected onto buildings as much as possible by preventing it.
Aluminium SunBlind profiles are used in the regions of the earth where there is a lot of sun rays. It is designed to save money by reducing the amount of energy used by air conditioners since the sun's rays reflected on the buildings in these areas increase the heating of the buildings.
To protect the sunblind profiles against sun rays, it is necessary to protect their surfaces. The anodized coating on sunblind profiles should be at least 15 microns because they are used on the outside of buildings.
When electrostatic powder coatings are used in aluminium sunblind profiles, these coatings should be used as Class II to protect them from the sun's ultraviolet (UV) rays and to preserve the coating on the surface longer. The paint warranty of Class II paints is approximately (25 to 30 years). In Africa and the Middle East, where ultraviolet (UV) sun rays are more intense, Class III is more fitting. Class III electrostatic paints are warranted approximately (30 to 50 years).
The architects of the companies that have obtained the design of the project the profile views of the sunblinds in various shapes and appearances. After the design, it is produced as an aluminium profile.
Mountings of aluminium sunblade profiles are usually attached by screwing them with stainless screws to the box profiles or flat profiles placed on the ground. These operations are performed by special assembly teams that perform these operations. These teams offer contracted services to the project companies' teams, as well as to the companies or companies that obtain the project as a subcontractor.